|
Post by admin on Jan 10, 2024 9:07:33 GMT
Recently I migrated from ESP-IDF v4 to v5 and that changed the inner workings of the scanner. Follow this guide if you are having scanner issues. 1. Download and unpack latest GUI version to a clean folder. github.com/laszlodaniel/ChryslerScanner/raw/master/GUI/ChryslerScanner/bin/Release/ChryslerScanner_GUI.zip2. Go to Tools folder, open a command line interface (CMD.exe) and wipe scanner with this command: esptool --chip esp32 erase_flash
3. Start latest GUI, try connecting to scanner: COM-port connect is ok but version info and status is not received. 4. Go to Tools / Update, ignore GUI version is latest message. Force latest scanner firmware update? Yes. Is this V2 scanner? Yes. ESP32 update starts. 5. Disconnect from scanner, then re-connect: version info and status is received. You are all up to date! If ESP32 update does not start then do the following: - before esptool tries to connect: press both scanner buttons - release reset button first - release boot button last - ESP32 flash update begins Reason behind this odd behavior: USB port/cable defects.
|
|
|
Post by benz140 on Jan 15, 2024 8:33:46 GMT
|
|
|
Post by admin on Jan 15, 2024 8:37:40 GMT
What is the part number of this SBEC3 PCM?
Show SCI-bus log from this session.
|
|
|
Post by benz140 on Jan 15, 2024 9:08:44 GMT
|
|
|
Post by benz140 on Jan 15, 2024 9:14:27 GMT
Какой номер детали у этого PCM SBEC3? Показать журнал SCI-шины этого сеанса. 04727512AK
|
|
|
Post by benz140 on Jan 15, 2024 9:15:02 GMT
на других блоках также
|
|
|
Post by benz140 on Jan 15, 2024 9:23:51 GMT
|
|
|
Post by admin on Jan 15, 2024 9:36:13 GMT
Analysis: seed request is ok, but the PCM responds with "invalid command (7F 27 C0)" when the scanner sends the key to unlock.
This part number is associated with the same SBEC3 protocol that we work with. Perhaps boot protocol was changed.
Can you dump the bootstrap code from this PCM with a debugger tool? Bootstrap ROM offset is between 0x0E0000 - 0x0E1FFF.
|
|
|
Post by benz140 on Jan 15, 2024 10:10:43 GMT
В старой версии программы\прошивки все работает, но только под WIN7
|
|
|
Post by admin on Jan 15, 2024 10:35:14 GMT
Ok, thanks for all the info!
I released a test update (FW v0.5.6) to address some timing issues. Let me know if you still get key error.
|
|
|
Post by benz140 on Jan 15, 2024 11:21:43 GMT
проверил. то же самое
|
|
|
Post by admin on Jan 15, 2024 11:29:25 GMT
Please show screenshots of old firmware with WIN7 working.
|
|
|
Post by benz140 on Jan 15, 2024 11:30:14 GMT
|
|
|
Post by benz140 on Jan 15, 2024 11:30:55 GMT
а вот так на старой версии
|
|
|
Post by benz140 on Jan 15, 2024 11:31:23 GMT
это на win10
|
|